The phrase "as a minimum value" is correct and usable in written English.
It can be used when specifying the least amount or lowest point in a range or set of values.
Example: "The budget for the project should be set at $10,000 as a minimum value to ensure all expenses are covered."
Alternatives: "at the very least" or "as a baseline value."
This difference can be regarded as a minimum value for the thin films studied and becomes much larger for thicker films.
We have recorded 74.1% as a maximum value and 65.8% as a minimum value.
Similarly, and taking into account the importance of the total assets value, we find that IIC represents 5.077% as a maximum value and 3.754% as a minimum value.
Second, in most cases, the apparent temperature values will be an underestimate of the true surface temperature, and thus they can be taken as a minimum value that often has use.
Thus, we assumed μ = 0.41 as a minimum value determined for a dry granular material with porosity 40% (Housen and Holsapple, 2011), and μ = 0.5 as a maximum value for relatively wet granular material with less porosity.
The thickness of these lamellae is very variable, as can be seen in the various TEM pictures in Raimbourg et al. (2011), and we consider 10 nm as a minimum value.
In general, as the acidity of the sol decreases, transmittance will decrease as well, reaching a minimum value at pH = 7.
It has been observed that thermocline thickness decreases as v∗ increases attaining a minimum value when v∗ ⩾ 2350 while tank efficiency increases with v∗ up to a maximum of about 87% also for v∗ ⩾ 2350.
For S > 0.11, ν decreases linearly with increasing S. As S exceeds 0.11, a minimum value of axial mean velocity along the center line uj,m due to flow divergence is found and it has a linear relationship with ν.
Energy band gap was calculated from optical studies and is varied from 2.41 to 2.45 eV where Cu=0.02 has a minimum value as 2.41 eV.
After phenol degradation starts, the oxygen concentration in the beads is found to be immediately reduced and slightly increased instantly, and then slowly decreased linearly to a minimum value as the degradation proceeds.
