Sentence examples for array width from inspiring English sources

The experiment results show that the SBC system with a microlens array has slightly better performance than that without the microlens array, which is almost consistent with the theoretical analysis results for the fiber array width of 0 2.5 mm.

Many studies that describe the formation of echelon vein arrays relate the causative stresses implicitly to the deformation, reliant on simple shear kinematics, such that the vein-to-array angle and the array width are the primary physical quantities.

This work considers an optimum design problem for the longitudinal fin array with constant heat transfer coefficient in a fuzzy environment, where rigid requirements to strictly satisfy the total fin volume and array width and maximize the heat dissipation rate are softened.

If we assume a focal length of 10 mm, an array with 500 pixels, and a field-of-view (FOV) angle of 30°, the sizes of a sensor element and array width are calculated to be approximately 10 and 5.2 mm, respectively.

At this distance the diameter of each LED, specified as a visual angle, was 4.9 minutes, center-to-center spacing of LEDs was 7.4 minutes, and the dimensions of the full array, width and height, was 7.7 degrees.

The RSS-MUSIC algorithm has larger estimation error when the angle difference is less than array beam width (16.4°), whereas when the angle difference is greater than array beam width, its estimation error will decrease with the increase of the angle difference.

For the alternating-width array, the slightly larger focal width leads to a 500-nm-wide beam having 16% of the total power incident upon it.

The maze is represented by an arbitrarily sized character array of defined width and height.

A novel 2 mm diameter, 7-element, 40 MHz array using equal width elements, instead of the more conventional equal area ones, has been designed and evaluated.

For the quartz glass, a high aspect ratio (about 10) structure of squared column array with the width of 10 μm and the height of 100 μm is formed from a grid pattern etched by 15 wt% HF for 15 min and 5 wt% HF for 90 min.

Therefore, periodicity of the array and the width of the rectangular hole are two factors in predicting the transmission peak's location.