This series of papers presents four novel experiments that were designed to study localised corrosion phenomena using an electrochemically integrated multi-electrode array namely the wire beam electrode (WBE).
As it is widely known, there are four typical methods for passive synthetic array, namely, the method introduced by Yen and Carey [1], Extended towed-array measurements (ETAM) [2], Maximum Likelihood method (ML) [3], and FFT Synthetic Aperture processing method (FFTSA) [4].
In addition, the sequence fragments that hybridize to the array, namely, the zipcodes, are located at the end of the probes, again facilitating the contact to the immobilized DNA sequences.
The upper part shows the uniform CNT arrays, namely the bristles.
The array pattern synthesis is done based on two parameters of the array; namely, excitation amplitude and element spacing.
For a woman to be truly productive, Wolf argues, a sexual partner must ply her vagina with what she refers to as "the Goddess Array" — namely, "a whole set of words, actions, and gestures that women cannot do without".
In the multi-speaker condition, scenes were pseudo-randomly mapped to one of three spatial regions across the nine speaker array, namely (1) a central region of speakers straddling 315° to 45°, (2) a leftward region straddling 270° to 0°, and (3) a rightward region straddling 0° to 90°.
Since we were comparing probe sets from two different array platforms, namely the MOE 430A (MM) and MOE 430 2.0 (MD) chips, the former of which contains half the probe sets of the latter, we anticipated and confirmed that approximately 50% of probe sets from the MD data would match corresponding probes in the MM data set.
A signal was considered "valid" when the Imagene software did not flag it (flag = 0) and when the same signal was observed on 2 thirds of the arrays, namely: 8 out of 12 for the somatic targets and 5 out of 8 for the embryonic ones.
After an explanation of the task, subjects were presented with an example of both types of arrays, namely S1 and S2 and the target orientation was indicated.
A model has been developed analytically to carry out the performance and optimum design analysis of four fin arrays, namely, longitudinal rectangular fin array (LRFA), annular rectangular fin array (ARFA), longitudinal trapezoidal fin array (LTRA) and annular trapezoidal fin array (ATFA) under convective cooling conditions.
