The phrase "array is fully" is not complete and lacks context, making it difficult to determine its correctness in written English.
It could be used in contexts related to programming or data structures, specifically when discussing the state of an array.
Example: "The function checks if the array is fully populated before proceeding with the calculations."
Alternatives: "array is complete" or "array is filled".
The array is fully populated with capacitive micromachined ultrasonic transducers.
The best-case scenario happens when the array is fully ordered.
In the worst-case scenario, the array is fully unordered; hence the function swap will be called every time.
The surface array is fully efficient above 3 × 1018 eV and, even if the hybrid mode can extend this range below 1018 eV, the second knee and a considerable portion of the wide ankle structure are left outside its operating range.
This array is fully described in the platform GPL17781 stored in the Gene Expression Omnibus (GEO) at NCBI (http://www.ncbi.nlm.nih.gov/geo).nih.gov/geo
While there is a potential for 204 molecules of GFP-LacI to be bound to this array (Lawrimore et al., 2011), it is unlikely that the entire array is fully occupied at any moment.
Participants were advised that during the test procedure, the prosthesis would be set to one of 3 settings: 'On', where the prosthesis was set to standard function, 'Off', where it was switched off completely and 'Scrambled' where the microelectrode array was fully functioning but the signal input would result in the electrodes being stimulated in a random, scattered pattern.
Sample 3 possesses a hybrid ZnO structure in which the interstitial voids between nanorod arrays are fully filled by ZnO nanoparticles (Figure 2c).
As shown in Fig. 2b the SEM image and magnified image (the inset) of three-dimensional pine tree-like hierarchical TiO2 nanotube arrays, the three-dimensional TiO2 nanotube arrays were fully covered and arranged homogeneously on the FTO glasses with large-scale and uniform growth and large amounts of short nanorod branches.
However, the dispersion state of Ag in this sample is probably suitable to enhance DSSC performance because of the following two reasons: (i) if the arrays were fully covered with Ag, dye molecules could not be adsorbed on TiO2; (ii) surface plasmon resonance of Ag nanoparticles shows not only absorption but also scattering of light, thus the bottom part of TNT arrays should not be coated with Ag.
The manufacturer guarantees that on the genomic level HuEx-1.0ST arrays are fully backward compatible with the U133 family.
