Min (minimum)—the smallest area of deviation between the two selected surfaces displayed in millimetres.
Max (maximum)—he largest area of deviation between the two selected surfaces displayed in millimetres.
From the bio-medical point of view the agreement is very satisfying since the measured values lie in general in an acceptable area of 5% deviation around the prognosis (green zone) for the first 5 hours.
Organizing genes, significantly regulated (up-red: down-green) by either BDNF or MeCh stimulation in both control or CMP cells, into heatmaps demonstrated several areas of considerable regulatory deviation between these two states for BDNF compared to MeCh treatment (Figure 5A).
MTR showed apparent left-right differences in some regions with lower values for right tibialis anterior, right rectus femoris and left semimembranosus, corresponding to the areas of maximum B1 deviation.
Blood glucose measurements (blue cross) vs simulated prognosis (red line), the deviation areas of 5, 10 and 20% are colored in green, yellow and red, respectively.
The following COP stability parameters will be computed: mean sway velocity, 95% confidence ellipse area, standard deviation of sway velocity, of medio-lateral COP data and of anterior-posterior COP data.
In catchments dominated by agricultural production, the performance of the IIMF is much better as only 30% of cropland and 23% of permanent grassland dominated areas have a deviation of > 30% between modelled and observed loads.
The standard deviation builds areas of uncertainty of the characteristics for later checking.
In the second part of this work, clusters of repetitive travels are identified and a Geographical Route Directness Index is proposed to identify the areas of the province where the deviation from the shortest alternative path is higher.
