Considerable differences were observed between urban and rural health service areas, densities of primary care physicians and specialists in urban areas were 7.69 and 5.84 per 10,000 inhabitants vs. 8.38 and 0.86 respectively in rural areas.
Three types of texture patterns were generated: dimples with 5%and50%0% area density (percentage of surface area textured); cross groove patterns with an area density of 64%; and concentric ring patterns with an area density of 70%.
The surface with an area density of 39.2% demonstrated the achievement of excellent tribological performance.
In Fig. S2a, only sparse SWCNTs are observed, while under identical growth conditions, the area density of SWCNTs was increased several fold when the pre-treated BNNFs were used (Fig. S2b).
For each packaging density, the frontal area density of arrays is varied from 0.125 to 0.5 through adding building blocks and reducing building size simultaneously.
Three different types of dimple geometry were designed with equal area density of 10.4% and EDM on test surfaces of aluminium alloy 7075 square pins.
The surface area density of the tested HTHE is 6 times higher than that of the bare bayonet tube heat exchanger.
Each pattern has the same area density of 7%, the same depth over diameter ratio h/d of 0.03, and dimple diameter d varying from 20 to 60 μm.
Climate had a strong influence on stand basal area, density of juveniles and proportions of seedlings and saplings in a population, as well as on prevailing disturbance regimes.
