Sentence examples for area of acceptable from inspiring English sources

The area of acceptable pedestrian wind comfort increases in oblique wind directions as the areas of high (>3.5 m s−1) and low (<1.5 m s−1) wind speeds are decreased.

The results reveal a strong dependence of the maximum wind speed in lift-up areas with building height, which results subsequently a small area of acceptable wind conditions near tall and slender lift-up buildings.

This imaginary line, which identifies the technology's stage of development at which it is sensible for a health service to invest research resources, sets the boundaries for the area of acceptable maximum risk.

Therefore, we computed a confidence ellipse for NRI cases and NRI non - cases to reflect precision of their estimates in combination and which also allows to evaluate the area of acceptable values.

He wondered whether the Chinese approach — expanding the areas of acceptable debate slowly and even fearfully — would wind up placing "a ceiling on the overall potential of the Chinese system".

In an e-mail he sent me a few days later, he argued — as he had in his 2012 book, "China Airborne" — that most modern societies try to "minimize the taboos and maximize the areas of acceptable debate".

The intersection area obtained for the metric MSSIM (Figure 11c) almost coincides with that for the metric PSNR. Figure 11 Areas of acceptable δ V and δ k for different noise cases with marked boundaries for appropriate estimation accuracy.

Although this acceptability of error 1.0 2.0 mm was found to be reliable, Kaipatur and Flores-Mir discussed that compounding areas of acceptable errors individually might lead to an overall unacceptable prediction [14].

In fact, this means that overestimation of mixed noise parameters is more risky for providing high visual quality of filtered images compared to the case of conventional analysis of denoising efficiency in terms of output MSE or PSNR. Figure 16 Areas of acceptable δ V and δ k for two metrics.

Finally, all items were located in the area of 0.5 to 1.5 (areas of acceptable fit), showing their usefulness for measurement [ 57].

The shaded area denotes the domain of acceptable values determined from the sensitivity analysis.