The phrase "area beam" is correct and usable in written English.
It can be used in contexts related to physics, engineering, or technology, particularly when discussing the characteristics of a beam of light or energy that covers a specific area.
Example: "The new laser system is designed to produce a wide area beam, allowing for more efficient coverage during the presentation."
Alternatives: "spatial beam" or "wide beam".
For future injection systems, in particular those based on negative ions, large area beam extraction and long pulse capability up to cw operation are envisaged.
This paper will present a summary of structural design of SGIII target area beam transport system, which include 276 transport mirrors and nearly 3000 m beam enclosures.
The relative sensitivity, confinement loss, effective area, beam divergence and marquise spot size are investigated by tuning distinct geometrical parameters like air holes diameter and pitch in the core as well as cladding region over a wider range (0.6 μm–2.0 μm) of wavelength.
By using a large area beam, with a power density several orders of magnitude lower, XEOL microscopy has the potential to provide similar information in a less destructive or non-destructive way.
This monomer solution (40 μL) was spread uniformly over the surface of the PS nanofibrous mat and PS dish, and then electron beam was irradiated using an area beam electron processing system (Curetron BBC-200-AA2 BBC-200-AA2 BBC-200-AA2yoto, Japan) at various radiation doses (acceleration Voltage of 150 Kyotoder 1.0 × 10−4 Pa).
co-op in a postwar building; part-time doormen, dining area, beamed ceilings, parquet floors, 2 exposures; maintenance $1,165, 53% tax-deductible; listed at $630,000 , 3weeks on market (broker: Benjamin James Associates) HUDSON HEIGHTS $459,0001600 Cabrini Boulevard 2-bedroom, 2-bath, 1,300-sq.-ft.
However, handling of the large-area beam is not easy and beam profile control on the wafer is even more difficult.
The required welding area between beam bottom longitudinal rebars and beam-end plates were calculated based on welding coefficients considered as a test parameter.
The properties of the FE elements depend on the element type such as cross-sectional area of beam element is known in ANSYS as real constants.
Recently, the emergence of nanopore fabrication technology with helium ion etching, which possesses smaller active area of beam spot and sample, overcomes the difficulty of conventional FIB, in which the diameter of nanopore is larger than 10 nm.
It is further observed that the variation in frequencies is predominant when τ w < τ h as compared to the case of τ w > τ h though the area of beam cross section is the same in both cases.
