The phrase "are limited below" is correct and usable in written English.
It can be used when referring to restrictions or constraints that are specified later in the text.
Example: "The resources available for this project are limited below the expected budget."
Alternatives: "are restricted below" or "are constrained below".
However, utility data exhibit peculiar characteristics that raise statistical challenges: they are limited at full health (1) and tend to have a mass of observations at that upper bound, they are limited below at the worst health state described.
Since the level of short circuit currents is not restricted in M1, the result of M1 cannot guarantee that the short circuit currents are limited below the safety threshold.
The case study shows that it can be achieved via the proposed approach that N-1 security is satisfied and short circuit currents are limited below the safety threshold after expansion planning.
Thus, the amount of CFBC fly ash replacement cement was recommended to be limited below 20%.
In terms of engineering property, environment and economic, the amount of OPC replacement by CFBC fly ash was recommended to be limited below 20%, while by GGBFS it was recommended to be limited below 70%.
Simulation shows that the error of the Janus configuration LDV after correction can be limited below 0.1% even as the VHR reaches 0.3 and pitch angle is 15°.
Considering the scope of value span, the reward value is limited below 0.5.
The rotary speed is always lower than 300 r/min (the rotary speed of the CE-5 is limited below 200 r/min), and the diameter of the drill tool is generally limited below 50 mm (the diameter of the CE-5 is limited below 32 mm) in the extraterrestrial exploration.
The CO2 concentration of seawater, therefore, must be limited below a certain value in order to minimize the environmental impact.
The design of the alternatives shall ensure that the maximum core fluid temperature is limited below the boiling temperature of water.
The coplanarity is limited below 0.2 mm (8 mil) by the Joint Electron Device Engineering Council (JEDEC) standard (JEDEC Design Standard, No. 95-1, Section 14, Ball Grid Array, June 2000).
