In the present study, bond strengths for brackets bonded to composite laminate surfaces pre-treated with both diamond bur and microetcher lie approximately within this acceptable range, being higher than the former.
When the scale of a sample is large, then the value of χ/df approximately 5 is acceptable.
Although our response rate was acceptable, approximately 30% of the patients declined to participate, and we do not know to what degree these patients differ from the participants.
Little (2013) notes that a RMSEA of approximately.08 provides an acceptable model fit.
These metrics define validity in its ability to capture patient-specific behaviors to a clinically acceptable level (approximately equivalent to measurement error).
In order to run a lecture with an associated practical dedicated to modern control systems for approximately 200 students with acceptable effort, it must be organized carefully and strictly.
Incidentally, since the length of an FEC block is 288 data bits, we find that only the adaptive weighted-average estimation method with QPSK achieves an acceptable BER (approximately 10−3) for E b /N0 ≥ 15 dB.
When the fault section in a radial distribution system is identified, then it is acceptable to approximately estimate the fault section based on the characteristic wherein the voltage along the feeder decreases.
Superior CBRAM characteristics such as high switching yield of 88%, lower average RESET current of approximately 328 μA, and acceptable resistance ratio of 9.6 are obtained for the 0.4-μm devices with a 2-nm-thick Al2O3 film under low voltage of ±2 V, which is due to lower diffusion of Cu ions into the Al2O3 films under external bias.
For the analyte level of approximately 1 μg/g, the acceptable recovery range is 80 110% (Taverniers et al. 2004; Huber 1998).
