Sentence examples for appropriate pressure drop from inspiring English sources
The main design philosophy is based on the determination of an appropriate pressure drop along the flow channel so that all the liquid water in the cell is evaporated and removed from, or carried out of, the cell by the gas stream in the flow channel.
(A) The owner or operator may determine gas stream flow using the design blower capacity, with appropriate adjustments for pressure drop.
In the evaluation, the appropriate single-phase pressure drop setting at the inlet orifice was determined in terms of response stability from the design viewpoint.
It found that the pressure fluctuation, which resulted from the variation of heat transfer mode, might be amplified under the condition of appropriate non-dimensional pressure drop in supercritical fluids natural circulation loop.
A Pareto front is constructed which enables designers to explore appropriate compromises between designs with low pressure drop and those with low thermal resistance.
Among them, three correlations are more appropriate and capable of estimating the pressure drop in the vertical flow system as follows: (a) Fancher and Brown (1963); (b) Hagedorn and Brown (1965); and (c) Beggs and Brill (1973 , 1991.
The optimum receiver configuration is established by finding an appropriate trade-off between thermal performance, service life, pressure drop, and material costs, by using the levelized cost of electricity (LCOE) as the objective function.
Design of a pipeline agglomerator to facilitate collection of submicron flame-synthesized aerosol powder post-quench must consider simultaneous aggregation and breakup to arrive at the appropriate pipe diameter to achieve desired cyclone efficiency under pressure drop constraints.
The flow channels should have an appropriate design to decrease the mass transport loss at a minimum pressure drop.
The choice of an appropriate characteristic length; and the selection of a way for correlating pressure drop data have also varied among researchers.
To this aim, an appropriate set of constitutive equations for effective heat conductivity of solid, pressure drop, and heat transfer coefficient were used for each reactor type.
