Sentence examples for appropriate conversion factor from inspiring English sources
We did not inflate the 2001 charges because we encountered problems identifying an appropriate conversion factor that considered veterinary medical services.
We could express an equivalent annual cost by using the capital recovery factor of standard interest calculations for loans which is the appropriate conversion factor.
Linear regression was used to evaluate the correspondences and to determine an appropriate conversion factor that could be applied, assuming uniformity of the molecular clock, to the relative divergence times of the viruses.
Although comparison of our results with previous reports of BMR in D. gliroides is complicated by the fact that different techniques were used, volumes of respiratory gases can be converted into power units using respiratory quotient and the appropriate conversion factor for different nutrients, as reported in Walsberg and Wolf (Walsberg and Wolf, 1995).
The first step is to calculate the dry weight concentration of the chemical on the suspended particles in the water column, Css, using the following equation: where Kd is the partition coefficient between suspended solids and water with units of L/kg, and SS is the suspended solids concentration with units of mg/L, and CF is the appropriate conversion factor (10−6).
Divide the area shown by the appropriate conversion factor to determine the acreage of the land.
The authors obtained primary data from surveys and used appropriate conversion factors to obtain the energy values.
(1) A comprehensive airflow study using single-point reading, moving traverse, and fixed-point traverse methods was conducted at the Safety Research Coal Mine, Bruceton, PA, to determine the appropriate conversion factors for sensor-measured air velocities.
Total microbial carbon and nitrogen were estimated as the difference between fumigated and unfumigated samples (expressed on an oven-dry mass basis), divided by appropriate conversion factors [44] [45].
The biomass was standardized to milligrams carbon per square meter using appropriate conversion factors from wet or dry weight to organic carbon weight [7], [9].
Appropriate conversion factors were used to convert the data to uniform units.
