Based on the synthesized virtual force, an applied thrust and a command attitude are extracted.
Additionally, the applied thrust on a blade was subject to frequent and periodical changes.
In Eq. (2), F is the applied thrust and A is the cross-section area of the bolt hole.
Also the input parameters to estimate the equivalent thrust per cutter are applied thrust per cutter, cutter spacing and cutter diameter.
During the full-scale testing, the tower resisted the applied thrust loads for both the perpendicular and diagonal directions without failure.
where, MB, kd and ka are the applied thrust per cutter (KN), the correction factor for cutter diameter as given in Fig. 7, and the correction factor for cutter spacing as given in Fig. 8, respectively.
Once the ship begins moving in a direction, it will continue in that direction for a time without player intervention unless the player applies thrust in a different direction.
The short-takeoff procedure involves proceeding with normal takeoff and then applying a thrust vector (less than 90°) at a runway speed below normal takeoff speed; usually the point of application is around 65 kn.
b With the fixation restriction, we were able to generate circumferences of 0.3 m applying maximum thrusting force with the maximum inclination in the joystick for different longitudinal orientation of the probe.
And third, they applied the thrust reversers harder than the system is designed for; that step may have slowed the plane, but the backward-rushing air destroyed the effectiveness of the rudder as a tool to keep the nose pointed down the runway.
Considerable axial penetration force is applied to thrust a sharp trajectory into the abdomen.
