Sentence examples for applying a frequency from inspiring English sources
Viscoelastic properties were measured using dynamic mechanical analysis applying a frequency sweep.
The 8-channel system is constructed by applying a frequency domain delay-and-sum (DS) beamformer prior to the feature enhancement to investigate whether multichannel setups gain from the proposed method.
By further applying a frequency hopping between 444 and 888 kHz, we further spread the emitted power whose maximum level is reduced by a factor of two, i.e., a total attenuation of 23 dB of the emitted peak power level is obtained.
These are the first steps in applying a frequency domain approach to deal with temporal microarray data.
The electroformation of pure DOPC and the DOPC/SM/cholesterol mixture was performed at room temperature and 60°C, respectively, by applying a frequency alternating current field (500 Hz, 100 mV for 10 min, 1 V for 20 min and 1.6 V for 2.5 hr) to the ITO electrodes by a function generator (Thurlby Thandar Instruments TG315).
Collecting data in movie mode using direct detectors has profoundly changed the way data is acquired and processed: many reported reconstructions have been obtained after eliminating sub-optimal frames (Li et al., 2013) or applying a frequency-dependent weighting scheme to the frames (Scheres, 2014).
However, we did not apply a frequency shift in the receiver channel.
At amplitudes of 0.5 and 1.0 ml we were able to apply a frequency range from 0 up to 2,000/minute, and at an amplitude of 2.0 ml a frequency range from 0 up to 800 sinusoidal deflections per minute.
Kuwana et al. [ 16] applied a frequency domain proton migration technique to measure the phase shift and thus the lifetime of a pH-sensing fluorophore, carboxy seminaphthofluorescein-1 immobilized on poly ethylene glycol) microparticles.
This frequency mixing is achieved by applying a net frequency shift to one arm of the interferometer, either by shifting just the reference arm or differentially shifting both arms.
The researchers make the silicon rods vibrate by applying a radio frequency voltage signal through the silicon base.
