Sentence examples for apply the switching from inspiring English sources

In Controller 4, instead of applying a switch controller on the angular velocity ω i, we apply the switching control to the forward velocity v i.

Finally, we apply the switching control strategy to destabilize an invasive tumor equilibrium and steer the system trajectories to tumor dormancy.

At the CET sub-layer is important to remark the importance of careful planning to avoid femtoBs overprovisioning, as well as, the need of coordination to apply the switching-off and cell breathing not only on the macroBS deployment, but also extend it to the femtoBS and relay level.

(15) Our ability to switch these molecules was indicated (predicted) by instabilities in the MDF signal prior to applying the switching field.

Reversible and irreversible charge-transfer models are applied to the switching reaction of polypyrrole films containing perchlorate.

Two schemes are considered with the present meta-heuristic approach to obtain a preliminary solution before applying the service switching concepts.

The proposed algebraic-based modeling framework follows the celebrated behavioral approach (see Polderman and Willems, 1998) and makes it possible to apply to the switched dynamics some classic techniques from the well-established time-invariant implicit systems theory.

The proposed algebraic-based modeling framework follows the celebrated behavioral approach (see Polderman and Willems (1998)) and makes it possible to apply to the switched dynamics some conventional techniques from the well-established time-invariant implicit systems theory.

Seconds later, when you start thinking straight, you slip the transmission into neutral, coast carefully to the side of the road, apply the handbrake and switch off the roaring engine.The first, and only, time it happened to your correspondent, the cause was a broken return-spring on the carburettor's butterfly valves.

This enables us to apply the theory of switched systems to establish the stability condition.

When a high negative voltage (−100 V) is applied, the state switched to high conductivity, referred to as the "0" state.