Differences between fractal-like and constructal approaches applied to disk-shaped heat sink designs are highlighted, and the importance of including geometric constraints, including fabrication constraints, in flow network design optimization is discussed.
An alternating electric charge is then applied to the disk and steadily increased, making the disk vibrate faster and faster.
Based on Sensi-disks from BD. Numbers following letters indicate ug of antibiotic applied to each disk.
Wu [15] studied both numerically and theoretically the effects of the thermocapillarity and thermoviscosity on spin coating when a radial temperature difference is applied to the disk surface.
In the experiments, the lubricants were initially applied to the disk surface but were not replenished over a sliding distance of more than 6000 m.
In particular, the penetration-per-revolution (p) recorded during excavation, the forces applied to each disk (FN), the Geological Strength Index (GSI) and uniaxial compression strength of the intact rock (σc) along the stretch have been compared.
The activity and specificity of the catalysts for peroxide production depend essentially on three factors: (i) the potential applied to the disk, (ii) the type of carbon support; and (iii) the concentration of the cobalt precursor.
6 Cadaveric studies 7 describe the anatomy as including an apophysis (secondary ossification centre) as '… extended from the antero-medial pubis to lateral limit of the capsular tissues closely applied to fibrocartilaginous disk, capsular tissues and deeper sub-chondral bone'.
The vocalization threshold based on the force of an applied force gauge (SMALGO algometer; Bioseb, Vitrolles, 13845 France) was measured by pressing the 0.5-cm2 device tip directly on the dorsal skin over the punctured disks (L4/L5) and comparing this threshold value with the force threshold applied to the disks (L4/L5) in the sham surgery control group.
Specifically, a marked decrease in manganese compounds was measured, which indicates a significant loss of the protective coating that was applied to the disks.
A static vertical load of 213 N was applied to the disks through the pin.
