Sentence examples for angles of friction from inspiring English sources

Internal angles of friction are partly quite high.

The angles of friction of the three layers of sand are 32°, 30°, and 26° from top to bottom.

Of the shear parameters obtained, the angles of friction best represented the known flow properties of powders and were in general agreement with those from other flow tests.

The experimental results confirm that both static and kinetic angles of friction between the belt surfaces and the coals tested are considerably higher than the presently recommended maximum inclination angle for belt conveyors.

Shear parameters, such as cohesion, angles of friction, and flow factors, were measured for microcrystalline cellulose, anhydrous lactose, spray‐dried lactose, mannitol, dibasic calcium phosphate dihydrate, anhydrous theophylline, and theophylline monohydrate powder.

Approximate agreement was also obtained with the published mass discharge rates of Nedderman and Beverloo for wedge and conical hoppers, respectively, and our results were insensitive to variations in internal angles of friction between about 25° and 35°.

The angle of friction of Panki and Panipat pond ashes (33.04° 37.68°) are in the range of angle of friction of reported Indian pond ashes and fly ashes, United State fly ashes and sand (25° 41.7°).

The soil root matrix significantly affects cohesion factor but not the angle of friction.

The angle of friction of Panki and Panipat pond ash samples varies from 36.53° to 37.68° and 33.04° to 34.28° respectively.

The most common one for a C-∅ soil is the tangent of two-third of internal angle of friction of the soil as the angle of wall friction value for the soil concrete interface.

Maksimovic (1996) proposed a non-linear joint failure model of hyperbolic type with three parameters: the basic angle of friction, the roughness angle and the median angle pressure.