Sentence examples for angle upwards from inspiring English sources

Later trials had it fixed at a steep angle upwards in both the Vickers Type 161 and the Westland C.O.W. Gun Fighter, an idea that would return later.

"Inside the underground Diocletian's Palace where there may or may not be dragons we wanted the flame to go at a very specific angle upwards and towards the ceiling.

It consists of a metal beam (Ø 1 cm, length 122 cm) coated with rubber attached to a rotarod apparatus (gradient angle upwards of 10°) which controls the constant rotating speed (4 rpm and 8 rpm).

instead, hold it at a slight angle upwards past your shoulder.

Tap the tree by drilling a 1⁄2 inch (1.3 cm) drill bit at a 45 degree angle upwards.

Apply a thick layer of eyeliner over the top eyelid, and curve it like an acute angle upwards.

The researchers found some snakes could glide for 24 metres.In this section Going round in circles Energy drain Slithering through the air ReprintsThe 3-D analysis showed the snakes take up a staggered posture when gliding, with their bodies angled upwards at about 25° to the oncoming air and their heads slightly higher than their tails.

It's angled upwards to take the pace out of the ball which subsequently drops comparatively gently into a bucket.

A 60 cm wide external netting overhang, curved in an arc and supported by lengths of heavy gauge wire, effectively precluded more feral cats and foxes than a 30 cm wide overhang angled upwards.

Most stems have near zero values of SGA adjacent to the pith followed by increasing positive angles (upwards to the left as viewed from the bark) over the next few rings to a maximum at around rings six to ten, before declining again to about the 15th ring and often changing to negative angles as the trees mature.

The highest levels of power and efficiency are associated with very large foil pitch angles (upwards of 70°) and angles of attack (30 40°), such that the flow is massively separated for much of the flapping cycle, in contrast to rotary turbines which rely on attached flow over as much of the rotor disk as possible.