The phrase "angle of the hole" is correct and usable in written English.
It can be used in contexts related to geometry, construction, or engineering when discussing the specific angle at which a hole is made or measured.
Example: "The angle of the hole must be precise to ensure a proper fit for the pipe."
Alternatives: "hole's angle" or "angle of the opening".
The shape of the laidback fan-shaped hole is defined by four geometric design variables, namely, the injection angle of the hole, the lateral expansion angle of the diffuser, the forward expansion angle of the hole, and the ratio of the length to the diameter of the hole.
The shape of the hole is defined by three geometric design variables, namely, the injection angle of the hole, the lateral expansion angle and the ratio of the length to the diameter of the hole.
The entry cone angle of the hole was varied from 90 to 150°, the speed varied from 0·29 to 0·69 m/s, and the vacuum pressure from 1 to 2·5 kPa.
"We've got all the elements — the shape of the green complex, the angle of the hole, the playoff event where you've got guys coming down the stretch — some could be going home, others moving on to Deutsche Bank next week in Boston, so there could be a lot more excitement to it".
When drilling oil wells, especially in directional drilling, it is very helpful to utilize a kind of measurement-while-drilling system to provide real-time monitoring to the direction of a bottom-hole assembly, the angle of the hole, the gamma radiation from formations, and some other physical parameters.
Down-hole sensors include three magnetometers and three accelerometers fixed tri-axially to measure the compass direction of the bottom-hole assembly and the angle of the hole which are then used to calculate the trajectory of the well along with depth.
Current threads of discussion include a scrutiny of the angle of the holes in the wood and their alignment.
In detail, the side facet angle of the holes after droplet etching is in the range of 27° to 33°, whereas the average side facet angle of the large holes is about 5°.
Furthermore the paper presents the relationship between the angles of the hole, the orientations of the flow injection and the film-cooling effectiveness.
Have the vertex of the angle (the point where the two rays meet to from an angle) inside of the hole at the bottom of the protractor.
Open image in new window Fig. 3 Diagram showing the relationship between the inclination angle of the entry hole to the cortex and the friction force.
