The phrase "angle of slide" is correct and usable in written English.
It can be used in contexts related to physics, engineering, or any discussion involving the slope or inclination of a surface where sliding occurs.
Example: "The angle of slide for the ramp must be carefully calculated to ensure safety during use."
Alternatives: "slope of the slide" or "inclination of the slide".
With the angle of attack as well as the angle of slide is set to be zero.
Their aerated (ρA) and tapped bulk (ρT) densities, angle of slide (σs), and angle of repose were measured.
By comparing this result with the angle of slide plane before grouting, we obtain their relations as follows beta_{0}^ = 1.22beta_{0}, (47) beta^ = 1.09beta.
It was also demonstrated that the angle of slide and the angle of repose of a given powder were conveniently correlated with its Hausner ratio, which is usually defined as the ratio of the tapped bulk density to the aerated bulk density.
Angle of slide is a specific parameter used to evaluate the flow properties of powder excipients.
Angle of slide was used to evaluate the flow properties of liquisolid tableting mixtures.
The results of sensitivity analysis using Monte Carlo simulation show that the friction angle of sliding surface is the most effective parameter in rock slope stability with plane sliding.
The selected probabilistic parameters are friction angle of sliding surface and apparent cohesion which are modeled using a truncated normal probability distribution function and the depth of water in tension cracks and earthquake acceleration ratio which are considered to have truncated exponential probability distribution function.
There is limited evidence in the literature to support a relationship between roof slope and angles of sliding friction for volcanic ash, although recent experiments suggest that dry ash is unlikely to slide off roof pitches less than about 35°, and that wet ash will adhere to the roof covering at even higher pitches (Hampton et al., 2015).
In order to analyze the effect of cement grouting in strata, the friction angle of the slide plane will be raised after cement grouting in the surrounding rock with steel pipes from ground surface.
The basal friction coefficient was also calculated, combined with the slope angle of the sliding path.
