The phrase "angle of bend" is correct and usable in written English.
It can be used in contexts related to geometry, engineering, or any field where the bending of materials or angles is discussed.
Example: "The angle of bend in the metal rod must not exceed 30 degrees to maintain its structural integrity."
Alternatives: "bend angle" or "angle of curvature".
The five inputs were angle of bend, punch radius/thickness ratio, die gap, die entry radius, yield strength to Young's modulus ratio and the strain hardening exponent, n.
Among these, 26 were left bends and the other 26 were right bends, as indicated in Table 3, where R is the radius of bend; Δ is the deflection angle of bend; Ve is the speed at curve entry.
The first parameter in relation (5a), on the other hand, indicates that the plane ADCB rotates about the line cc (in the y-direction) and B 6 is the angle of bending γ per unit length.
The analytical solution of the crushing resistance was derived and the two types of deformation modes were identified using the analysis of the fully plastic bending moment with different orientation angle of bending axis.
The expression is quantitatively exact for beams with any angle of bending even when paraxial condition is not satisfied i.e. beam cross-sectional diameter is comparable with the radius of curvature of bending.
A non-linear piezoelectric dual sensor consisting of one-directionally and randomly aligned bi-axially grown zinc oxide nanorods was introduced for simultaneous detection of the bending radius and angle of bending deformation.
Surprisingly, this bending did not lead to the breakdown of the tubular structures unless the angle of bending exceeded 90°, and even then the two sections still remained connected.
Bend this tool to the angle indicated on your frame, and then match the bending angle of your bending tool to this angle.
Students needed to consider a variety of facts and concepts, from the angles of bends to the various tendons and ligaments connecting muscles and bones.
After making each bend, lay the pipe against your frame to check that the angle of the bend is correct.
Figure 6 shows the obtained relationship between the angle of the bend made by the propagation path and the corresponding interaction loss of Equation (2) for layered drywalls.
