Sentence examples for angle failure from inspiring English sources

The photographic view of the deformed shape of the connection and the angle failure is shown in Fig. 2a, b.

Friction angle at failure state.

β is the angle of failure criterion.

For small friction angle, the failure surface tends to be planar.

The UCC strengths were calculated based on the angle of failure plane obtained from the failed specimens.

Also, it can point out that as the contact angle increases, failure could initiate in locations closer to the geometric center of the disk ( left( {{{m = r} mathord{left/ {vphantom {{m = r} R}} right. kern-0pt} R} to 0} right) ).

The objective of this paper is to contribute to find an explanation for the appearance of an angle of failure of about 53°, referenced by several authors, in the case of compression transverse to the fibres.

The peak torque and angle at failure were measured from the torque-angle deflection curves.

The angle of failure and the maximum load were determined as material characteristics and the torsional stiffness (N/°) was calculated as a biomechanical parameter.

Firstly, the force that is needed to break the bone, characterized by maximum torque, as well the angle of failure that is used as a parameter of the flexibility of the bone, were measured.

Interestingly, the angle of failure in the wild type group (128%) was comparable to the hTNFtg + TNFi group (98%), but significantly increased in the hTNFtg group (221%, wild type vs. hTNFtg: p = 0.0293; hTNFtg vs. hTNFtg + TNFi: p = 0.014).