The phrase "angle and electrical" is not correct or usable in written English as it lacks context and clarity.
It could potentially be used in a technical or specialized context where both terms are relevant, but it needs additional information to convey a clear meaning.
Example: "The angle and electrical specifications must be considered when designing the circuit layout."
Alternatives: "angle and voltage" or "angle and power".
The topological and chemical characteristics of this sensor are obtained by TEM, SEM, EDX, contact angle and electrical measurements.
The structural, morphological, optical, wettability and electrical characterizations have been carried out by means of X-ray diffraction (XRD), Scanning electron micrograph (SEM), Fourier transform infrared spectrum (FTIR), optical absorption, contact angle and electrical resistivity studies of deposited films.
The effects of UV-C irradiation on the surface hydrophobicity and on the electrical properties of the epoxy/graphene films were investigated using contact angle measurements and electrical impedance spectroscopy, respectively.
These methods are used to control the pitch angle and maximize electrical power generation [11].
where is the reflection coefficient which is dependent on the incidence angle and the electrical parameters of the object ( is zero in the case of an aperture), and the vector cross-product with the normal to the surface,, represents the calculation of the tangential component.
The ODA-functionalized MWCNT films exhibit a high water contact angle of 165° and electrical conductivity of 860 S/m.
X-ray photoelectron spectroscopy, Auger electron spectroscopy, ultraviolet-visible spectroscopy, scanning electron microscopy, transmission electron microscopy, water contact angle measurements, ellipsometry, and electrical measurements were employed to characterize the materials and the resulting device performance.
ω i, δ i, P mi, and P ei are rotor speed, rotor angle, mechanical power, and electrical power of generating unit i. Δf j and P j are the bus frequency and active power of load j.
In a storm, the wind turbine is slowed down by adjusting the pitch angle and the maximum electrical load.
Both used a 45 degree angle glass beam splitter and electrical illumination and were used to aim the plane's machine guns.
Figure 4 shows interactive effects of progress rate and angle on electrical resistivity of the sample containing MWCNTs at 1.5 wt% with manually set laser machining.
