Sentence examples for and validate the procedure from inspiring English sources
The collected database which covers more than 27,000 buildings is used to train and validate the procedure.
Finally, two case studies available in literature, related to both cases of sound and corroded existing columns, are analysed in order to clarify and validate the procedure and to suggest some improvements of the HPFRC jacket technique.
Efforts are underway to standardize and validate the procedure.
Current research is going to optimize the assay conditions and validate the procedures for the routine application in clinical laboratories.
These results are reassuring and validate the procedures used for randomization.
For developing the heat exchanger model in detail and validating the procedure against observed results, the specific case of a process waste heat boiler provided with a bypass is considered.
In this report, we first used DNA from a cancer cell-line (SKBR3) to optimize the aCGH protocol for automated hybridization, and subsequently optimized and validated the procedure for FFPE breast cancer samples.
It is built up based on the requirements specification, architecture definition and per-layer development that constitutes the whole GEYSERS ecosystem, and validates the procedures on the GEYSERS prototypes.
Design procedures for partially stiffened elements previously inferred from numerical studies are shown to accurately and reliably determine the plate strengths, and further validate the procedure for use as a general strength approach in current international cold-formed steel specifications.
To gain insight into the mode of coupling (Figure 3) of DHI during polymer buildup in this procedure, which is important to match the basic structural features of the immobilized DHI-derived polymer [30, 32] and to validate the procedure, mother liquors were collected and the reaction was stopped in the early stages by the addition of sodium dithionite to reduce the oxidized species.
To compare the results and to validate the procedure, a model of the NREL PHASE VI wind turbine was first implemented [7], calibrating the model using experimental data found in scientific literature [9].
