The phrase "and the total flow" is correct and usable in written English.
It can be used when discussing measurements, calculations, or processes that involve a cumulative or overall flow, such as in engineering, fluid dynamics, or data analysis.
Example: "We need to assess the efficiency of the system by analyzing the input and the total flow of resources throughout the process."
Alternatives: "and the overall flow" or "and the cumulative flow".
The results indicated that the saturator temperature and the condenser temperature had a greater impact on the cut-off size D50 than the capillary flow rate and the total flow rate.
Variations of the trimethylgallium and hydride flow rates, changes in the composition of the mixture supplied through the hydride inlet, and the total flow redistribution between two reactor inlets have been considered.
The topology, length, and strength of these flow paths can vary significantly, and the total flow at a given location can be the result of contributions from a wide range of pathways between the points of interest.
The results show that in low-permeability reservoirs, electrokinetic coupling effect can increase fluid flow resistance and the total flow rate becomes smaller compared with the case in which the electrokinetic coupling is not considered.
The influence of several operational parameters including the saturator temperature (35 to 45 ℃), the condenser temperature (10 to 25 ℃), the capillary sample flow rate (30 to 60 mL/min) and the total flow rate (300 to 400 mL/min) on the cut-off size D50 (particle diameter with 50% counting efficiency) was investigated using response surface design of experiments (DoE).
Outputs used for comparison were related to the total demand generated and the total flow reaching the destination.
It is not possible to tell how much of the water in the stream has come from seepage flow and how much from storm flow, and so the total flow cannot be correlated with rainfall records; the only way to predict water yield is from past records of flow.
Carbon dioxide and methane conversions were enhanced with increasing the input power and decreasing the total flow rate.
These MMs fit separately the baseflow and excess flow components as produced by a digital filter, and reconstruct the total flow by adding these two signals at the output.
During that 87-day period, BP managed to avoid capturing (and measuring) the total flow from the well, even though they had vessels and equipment on site to do so.
The goal is to maximize the flow through the network while not exceeding bounds on the budget and on the total flow cost.
