The phrase "and the tolerance value" is correct and usable in written English.
It can be used in contexts where you are discussing measurements, specifications, or limits in various fields such as engineering, manufacturing, or quality control.
Example: "The final product must meet the required dimensions and the tolerance value to ensure proper functionality."
Alternatives: "and the acceptable range" or "and the allowable limit".
The learning rate and the tolerance value were 0.2 and 0.05, respectively.
This tolerance zone, unless otherwise stated, is taken to be equally disposed about the true form, and the tolerance value is equal to the diameter of circles whose centers lie on the true form.
Similarity was computed using the Dice coefficient and an unweighted pair group method with arithmetic mean (UPGMA), with optimization set to 1.5% and the tolerance value set to 1.25%.
The regression variables were checked for multicollinearity, and the tolerance values were considered acceptable.
We tested multi-co linearity for all independent variables, and in no case was the tolerance value less than 0.1 or the variance inflation factor (IVF) greater than 10 (Table 1 ).
Therefore Table 1 illustrated all the possible variations in key length and the corresponding performance (EER) with the tolerance value.
Possible high inter-correlations among the independent variables were checked for, using multiple regression analysis and ensuring that the tolerance values for collinearity statistics were adequate (>0.1).
Collinearity was assessed by examining the tolerance values and variance inflation values for the independent variables in the final regression models; values < 0.1 and > 5, respectively, were considered to suggest problematic collinearity [ 17] (no problems with collinearity were found within the analyses carried out).
MATLAB can provide similar results for relative and absolute tolerance values in the range of 10-1 -10-6, nonetheless, RoadRunner has produced computational model simulations comparable with MATLAB results for the tolerance values between 10-4 and 10-5.
The tolerance values were between 0.31 − 0.76.
The tolerance values in Table 4 represent production potential when salinity is the only limiting factor.
