The phrase "and the maximum voltage" is correct and usable in written English.
It can be used in contexts discussing electrical systems, specifications, or measurements where maximum voltage is relevant.
Example: "The circuit must be designed to handle the current load and the maximum voltage to ensure safety and efficiency."
Alternatives: "and the peak voltage" or "as well as the highest voltage".
In this case, finally we decided the resistance of the coils to be 21.5 ohms each and the maximum voltage we can add between its two ends is about 25 Volts.
The average discharge voltage of the battery is 0.53 V higher when heated by 240 W power compared to 90 W power, and the maximum voltage differential is 1. 38 V. Therefore, increasing the heating power above 90 W can improve the discharge voltage and thereby increase the discharge power but does not significantly affect the discharge capacity.
ADP amplitude was defined as the voltage difference between the peak of the fAHP and the maximum voltage between fAHP and sAHP.
The maximum sampling frequency was 100 Hz, and the maximum voltage range was ±10 V.
Without the pellet reactor and using RO concentrate as feed of ED in feed and bleed operation, the ED was rapidly scaled and reached the maximum voltage.
Attach connector of DC motor with voltmeter and spin its pulley with your finger as fast as possible and note the maximum voltage produced by this movement.
It is convenient to remember that FF and η% are described by Eqs. 4 and 5, where P MAX (= V MAX ⋅ J MAX) represents the point of maximum power generated by the cell, and V MAX and J MAX represent the maximum voltage and current values, respectively, that maximize the power P MAX.
This process was repeated five times and normalized to the maximum voltage response (Vmax).
The participants did as instructed, and most teachers administered the maximum voltage, despite the screams of the learners.
The maximum voltage and current were set as 8,000 V and 50 µA/strip, respectively.
For checking and determining the maximum and the minimum voltage, we start comparing the maximum voltage (Pre initialized to 0) and the minimum voltage (Pre initialized to 255) with the value of the count, and start upgrading their values.
