The minimum values occur in the winter of 2006 and the maximum values are in the equinox of 2004.
In fraction F1, the minimum and the maximum values of Cd were found at the locations, Ka and C, respectively.
The rupture and elasticity moduli of the boards decreased with an increase in the RNP content, and the maximum values were obtained at RNP loading of 10%.
The ratios between the measured witnesses and the maximum values achieved by classical mimicries are observed to increase with d for both EPR and SS steering.
Assume A = 100, and the maximum values in the side information are given by B = 75, C = 50, and D = 25 or D = 5.
The binary states of 0 and 1 could then be defined as the minimum and the maximum values of R, respectively.
Error bars on the averages indicate errors estimated by assuming the nutrient concentration for the missing data period lies between zero and the maximum values.
The optimum values of the process variables for the maximum decolorization efficiency and the maximum values of decolorization that were verified experimentally are shown in Table 6.
The vibration amplitude (lateral and vertical) and vertical acceleration increase with the increasing load, and the maximum values are 0.041, 0.43 mm and 0.44 m/s2, respectively.
The valuable information is that the lateral and vertical acceleration increases as the speed increases, and the maximum values are 0.15 and 0.62 m/s2, respectively.
Transient behaviors of shear stress acting on the plates, the flowrate, and the maximum values of the velocity, and the tilt angle between the plates have been reported.
