Sentence examples for and the maximum strength from inspiring English sources

It seems with volume fraction of steel fibers, more than 2% of the efficiency of the concrete mix decreases and the maximum strength could be decreased.

Therefore, the optimum amount of GWG microparticle may be 20%% as cement replacement, and the maximum strength achieved by 5%% GWG replacement.

In Fig. 5, it is observed that increasing of lime content causes significant improvement in compressive strength of the soil at in all of the pozzolan contents, and the maximum strength is achieved at 5% lime approximately.

Marble dust addition decreases the strength of OPC and the maximum strength of 54.5 MPa has been achieved on 28 days of curing with 20% of marble dust (CM20).

The transitions of the stress-strain behavior and the maximum strength in the two methods show overall good agreement.

A 0.4 m fractured zone at roof holes was ignored and thus the maximum strength of the coal was 17.85 MPa, the minimum was 7.65 MPa, and the average was 12.43 MPa.

For strain rates greater than 2.00 × 10− 3 s− 1, as the moisture content increases, the strength first decreases to a minimum value, then increases to a maximum value, and finally decreases toward that the ice strength; the minimum strengths are not always less than the ice strength, and the maximum strengths are not also always greater than the strengths at the optimum dry densities.

According to the eigenvalue analysis results, the fundamental natural period along the transverse direction is 0.41 s, which is almost the same with that of the model SD. Figure 14 shows the pushover curve of the model CD, in which it can be observed that both the yield and the maximum strengths of the structure are smaller than those of the model SD.

Hydrothermal influence in adhesive bonded joints was observed by Soykok [18], considering the heat and moisture ageing process the maximum strength and stiffness of joints reduce by a significant value after a period of exposure at hot water.

This paper presents an experimental study of the geometrical and installation parameters affecting the maximum strength, failure mode and load-slip response of FRP anchors.

Although the predominant activities during training and matches are performed at low and medium intensities, sprints, jumps, duels, and kicking, which are mainly dependent on the maximum strength and anaerobic power of the neuromuscular system, are essential skills [40].