The phrase "and middle values of" is correct and usable in written English.
It can be used in contexts involving statistics, data analysis, or discussions about ranges and distributions.
Example: "The report highlights the average, median, and middle values of the dataset to provide a comprehensive overview."
Alternatives: "and central values of" or "and intermediate values of".
The upper and middle values of the evaluation rates, starting rates, and completion rates were based on unpublished data from selected California local health jurisdictions.
The purine/pyrimidine ratio (R/Y) exploits the whole range of natural values (~1.0-1.4 ~1.0-1.4atd middlowvandes of the genomiddle content (Additional file 1: Figure S6).
Therefore, among the males and females chosen for this experiment, middle body lengths and middle values of MCG and FTG, were underrepresented in comparison to the natural bell shaped distributions.
We define the center of hand candidate area as a coordinate of the flow vector, which has the length and angle nearest from the middle values of flow vectors.
Finally, a sensitivity analysis to the choice of the diagonally dominant constant ϵ was conducted, where the middle values of M = 1 and E k ϵ [50, 100] were used.
If we look at medians, or the middle values of savings accounts, these numbers change dramatically.
In OIS with middle values of reactivity R, both networks may be dominant, depending on the prevailing product in the organic component.
Therefore, the COD value of a dicamba was taken as a reference and the middle value of H2O2/COD ratio was considered as the 2.125 (theoretical relation), in which the maximum number of ·OH radicals are produced (Kim et al. 1997) and the value is near to 2.15 in the previous literature (Kavitha and Palanivelu 2004).
The steps taken below read in the file into a crate, extract the x and y column values, change the middle value of each column, check to see what values are stored in the crate, and then write out the crate to a new file.
It is noticed from the Fig. 6 response surface plot that GRG is maximum at middle value of current and a higher value of Ton.
For MHE, the middle value of each interval was used in the discrepancy calculation, and the weight coefficient (the parameter ρ in [12]) equals to 0.8 was used.
