Sentence examples for and decreasing the speed from inspiring English sources

With only a pair of editing scissors, two tape machines, and a vari-speed control, Emerick compensated for the differences in key and speed by increasing the speed of the first version and decreasing the speed of the second.

The one speed profile in Fig. 16a increased the speed during the upstroke to maximize efficiency and decreased the speed on the down stroke to eliminate pounding against fluid columns.

Its theory of energy-saving is that the inertia load induced by acceleration of the moving parts is redistribution in the overall time of one stroke that can increase the speed of motor in the low load and decrease the speed of motor in the high load.

Its theory of energy-saving is that the inertia load induced by acceleration of the moving parts is redistribution in the overall time of one stroke that can increase the speed of motor in the low load and decrease the speed of motor in the high load.  .

During inflammation, pain increases the braking effect (i.e. increase Kout) and decreases the speed to cross the tunnel.

The model of rolling flow in the droplet indicates that slowing translation would both increase the duration that DNA molecules spend in close proximity to the surface (increasing the likelihood of tethering) and decrease the speed of the upward flow at the trailing edge of the droplet (decreasing the likelihood of detachment of DNA molecules from the surface).

For VCFSW process, increasing the rotational velocity and decreasing the welding speed are beneficial to break the compensation strip into pieces to get the higher quality welding joint.

It was demonstrated that cutting forces are significantly reduced by increasing the vibration frequency and vibration amplitude, and decreasing the sawing speed in the current design.

Increasing the amplitude of the acoustic wave and decreasing the printing speed allow for narrower distributions of particles in printed lines but increase the time and energy needed for the print.

It is also demonstrated that supercritical Hopf bifurcations take place at this controlled optimal configuration without having any hysteresis and jumps when increasing and decreasing the wind speeds.

With cutting parameters in the current study, increasing the cutting speed and decreasing the feed produced thinner chips (smaller chip thickness).