The phrase "and allowable to" is not commonly used in written English and may sound awkward.
It can be used when discussing permissions or regulations regarding what is permitted in a specific context.
Example: "The new policy outlines what is acceptable and allowable to all employees in the workplace."
Alternatives: "and permitted to" or "and authorized to".
"Under certain circumstances, it may be advisable and allowable to target second-party persons and second-party communications unilaterally when it is in the best interests of the US".
"Therefore," the draft memo continues, "under certain circumstances, it may be advisable and allowable to target second party persons and second party communications systems unilaterally, when it is in the best interests of the US and necessary for US national security".
"Under certain circumstances, it may be advisable and allowable to target second party persons and second party communications systems unilaterally when it is in the best interests of the US and necessary for US national security," says the directive, which was classified as "NF" for No Foreign and is titled Collection, Processing and Dissemination of Allied Communications.
The probability distributions were compared on the basis of goodness of fit, nominal design values, and allowable load to achieve uniform reliability.
Last month, Toyota agreed to pay a $17.35 million fine — Toyota's fourth since 2010 and the maximum amount allowable — to settle allegations by the National Highway Traffic Safety Administration that the automaker delayed a safety recall.
Contribute the maximum allowable to your 401(k) and a Roth IRA.
Governed by varying state laws, payments to trustees are generally allowable to the extent that they are "reasonable and necessary," Mr. Eisenberg said.
The door fee is $1,000 minimum, and some ofthose attending are expected to give $4,950, the maximum donation allowable to an individual candidate.
Because of the extreme danger, the use of glues containing benzene has stopped in most developed countries, and allowable worker exposures to the chemical have been drastically reduced.
Based on the geotechnical investigations of the dam site, the geomechanical parameters of most regions of bedrock are as follows (Mahab Ghodss Consulting Engineering Company 2003): unit weight = 25 kN/m3, deformation modulus = 11.0 GPa, Poison's ratio = 0.25, friction angle = 42°, cohesion = 0.5 MPa and allowable bearing capacity: From 9 to 14 MPa (Used 12 MPa).
Using such a penalty function, in cases where there is a marked difference in elasticity between contacting bodies, contact stiffness and allowable penetration must be adjusted to achieve convergence (Żmudzki 2011; Żmudzki et al. 2013b).
