The phrase "and a modulus of" is correct and usable in written English.
It is typically used in mathematical or technical contexts to refer to the modulus operation, which finds the remainder after division of one number by another.
Example: "The equation can be simplified to x mod y, and a modulus of 5 will yield a remainder of 2."
Alternatives: "and a modulus value of" or "and a modulus equal to".
It had a thickness of 0.635 mm and a modulus of 124.1 GPa.
The mechanical properties of the cured CFRP system were tested and showed an ultimate strength of 3208 MPa and a modulus of elasticity of 234 GPa.
The collagen sponge with a density of 129 mg/cm3 showed a compressive strength (to a strain of 30%) of 8.88 kPa and a modulus of 332 kPa.
From these diagrams it is possible to derive and consequently to determine tensile strength, yield strength and a Modulus of elasticity.
Consequently, by prolonging the pendant chain length to C18, the cured resin exhibits a striking tensile strength of 90.65 MPa, an elongation of 6.1% and a modulus of 2.55 GPa.
The results showed that the maximum compressive strength of 32.8 MPa at 28 days could be achieved at the optimal Na2O content of 4.0% and a modulus of 0.95.
To do so, let us decompose the output index of the convolution m into both a multiple-of- Nss term (m b ) and a modulus-of- Nss residual (m r ) according to the desired polyphase order.
Mammeri et al. performed nanoindentation studies on class II poly methyl methacrylate) (PMMA) /SiO2 hybrids and found a modulus of 6.60 GPa and hardness of 0.54 GPa.[ 16] The class II γ-PGA/SiO2 hybrids, 2EC, synthesised in this study had a lower relative modulus, perhaps owing to the inherent stiffness of the PMMA and from the higher curing temperature of 100 °C used in the Mammeri study.
The fibers are made of a modified polyolefin and have a modulus of elasticity of about 10 GPa and tensile strength between 550 and 640 MPa.
Using this set of modulus of elasticity values did not result in good agreement between results of Abaqus/Cae and LPILE; therefore, it was necessary to further refine and hence a modulus of elasticity of 30,000 kPa was used.
A mapping providing such a for a given and is called a modulus of uniform convexity.
