The phrase "analysis to decrease the" is correct and usable in written English.
It can be used in contexts where you are discussing methods or strategies aimed at reducing something, often in a technical or academic setting.
Example: "The analysis to decrease the error rate in our calculations revealed several key factors that needed adjustment."
Alternatives: "evaluation to reduce the" or "assessment to lower the".
A visual analysis of the two- and the three-class models was carried out to determine if any of the items should be removed from the analysis to decrease the complexity of the model.
We did not carry out a sub group analysis to decrease the heterogeneity between various studies.
For each element, more than one wavelength was used for analysis to decrease the possibility of matrix interference.
We included the treated samples into the analysis to decrease the inevitable bias induced by inflammation, as shown in the section above.
In contrast, white matter lesion volume had a markedly skewed distribution and therefore scores were log transformed before analysis to decrease the impact of extreme observations.
When data were split to differentiate results obtained in healthy donors versus septic patients or when only one sample per patient was kept in the analysis (to decrease potential bias associated to serial sampling from the same patient), correlation parameters remained very good (Fig. 2a).
A project in a low-income community in Washington State is implementing multilevel strategies including innovative housing for people with asthma, clinical asthma care, in-home education, and resident empowerment, along with scientific assessment and analysis, to decrease asthma morbidity and improve the built environment of public housing.
Unable to blind patients or physicians, we are using the techniques of baseline data collection before randomization, automation of outcome assessment, and blinding of the data analysis to decrease observer and assessment bias.
Finally, this was followed by a dynamic analysis of the whole transcriptome (using Gene Expression Dynamics Inspector and cluster analysis tools) to decrease the high dimensionality of the data and annotate coordinated genome wide responses that occur over age and by genotype.
In the simulations for Bragg mirror, we used λ BM =700 nm, n 1=1.47, and n 2=2, whereas the number of layer pairs, N L, is varied from 1 to 3. We chose this number of layer pairs to facilitate the analysis, namely, to decrease the number of analyzed modes, since the number of layer pairs directly determines the number of modes.
This quantitative rather than qualitative comparison done by fractal dimension numerical analysis helps to decrease the quality assurance errors in IMRT dosimetry verification.
