Sentence examples for analysis times for from inspiring English sources

The HS-SPME IMS metHS-SPME IMSy-DS fiber, provided good repeatability (RSDs < 10 %), simethodty, good sensitivity and short analysis times for spiked soil (200 ng g−1) and withr samples (100 and 200 ng mL−1).

Peak and background analysis times for Si, Ti, Al, Fe, Mg and Ca were 20 s and 10 s, for Mn, Ni, Cr, P 30 s and 10 s, for S 50 s and 25 s, while for Cl they were 240 s and 120 s, respectively.

The analysis times for triM and GridQTL are shown in Table 1.

A drawback of multidimensional methods is the time frame, as typical analysis times for 2D-LC analysis of peptide mixtures range from several hours to more than 1 day [ 1– 4].

Analysis times for pemetrexed on HPLC- or LC-MS instrumentations are between 7 and 20 min [ 3, 5, 17] per sample measured by HPLC and up to 30 min per sample for LC-MS [ 18] while the MALDI-QqQ-MS/MS assay has an analysis time of approx. 10 s per sample (Fig.  1).

The overall analysis time for the LAMP assay method was approximately 24 h.

The overall analysis time for the LAMP assay was approximately 24 h.

According to the data of chronoimpedance, the total analysis time for EIS was chosen as 3 min.

Overall, the total analysis time for the CGE method was much shorter, allowing analysis of 100 samples in 4 days instead of 10 days for SRID.

The total analysis time for a single sample, including the pre-treatment and measurement, was less than 5 min with a PQ detection limit of 10 nM.

Total analysis time for this automatic assay was about 30 min as compared to the 5 8 h used in conventional batch well ELISA.