The phrase "analysis condition" is correct and usable in written English.
It can be used in contexts where specific conditions or criteria are set for conducting an analysis or evaluation.
Example: "Before proceeding with the experiment, we must establish the analysis condition to ensure accurate results."
Alternatives: "evaluation criteria" or "assessment parameters".
Microstructure analysis (condition of gel and degree of hydration) confirmed the results.
A novel quadratic stability analysis condition for affine fuzzy systems is derived in the formulation of linear matrix inequalities (LMIs), which is equivalent to existing results.
The influence of pH of the supporting electrolyte on the ATRA oxidation peak was also evaluated and the optimal analysis condition was observed to occur at pH 5.0.
For that aim, a robustness analysis condition is given in terms of a linear matrix inequality feasibility problem, producing less conservative results than recent parameter dependent Lyapunov based methods (which encompasses quadratic stability) for polytopic uncertainties in linear systems.
Differing from existing ideas in the literature to reduce filtering conservatism, the present article proposes a less conservative two-stage algorithm to handle this issue by stepwisely recovering and utilizing matrix variable information of analysis condition.
By utilizing reciprocally convex approach, firstly, sufficient reliable dissipativity analysis condition is established in terms of linear matrix inequalities (LMIs) for singular systems with time-varying delay and sensor failures.
The ROC_AUCs were 0.817 for the study data set under the conditional logistic regression analysis conditioned on the matching factors.
N.T.K. and C.D. set up SIMS analysis conditions and assisted with the analyses.
Specific analysis conditions must be defined for each analyte.
It is important to note that all SEM micrographs were captured using the same method and analysis conditions, supporting the substrate specific lysis effects.
The analysis conditions were optimized and the performance of the proposed method was investigated.
