Sentence examples for an incremental sample from inspiring English sources

Then, an incremental manner is employed to update minimal elements in the discernibility matrix at the arrival of an incremental sample.

For official controls the sampling frequency (SF) is calculated according to Equation (5) and sets down that from every nth item an incremental sample should be taken.

The sampler was operated by compressed air and an incremental sample was collected every 7 8 s for 2h, and by adjusting the frequency of sampling a representative sample with the specified mass can be formed from an arbitrarily sized lot (http://www.tagumatic.dk).

Special care was taken to turn off the interactions between injected particles in the simulation so that the computed filter efficiencies reflect an incremental sampling of pore throat sizes, and thereby can be used to infer the PoSD.

In addition to the analysis of an aggregate sample of 10 kg composed of 100 g of each incremental sample, a portion of every incremental sample was individually analysed for OTA.

Prior to recording full 4D HC CC-TOCSY CO))NHC CC-TOCSY COwe recorded the 15NH1H 2D planexperimentxperiment using a full (incremental) sampling list since our methodology is applicable if the number of signals observed in the 2D plane are ≥50% of expected, based on a standard, sensitivity-enhanced 2D 15N/1H HSQC experiment.

Two of these studies described the use of incremental sample sizes across cycles, three used non-incremental sample sizes across cycles, and one changed the type of sample.

SF depends on the weights of the lot, the incremental sample, the aggregate sample and the individual packing (European Commission 2006a): Proper attention must still be paid to sampling of cereal-based foods at the retail level because OTA concentrations in retail products can differ amongst products and over time.

In, for example, European Commission Regulation 401/2006 for official control of mycotoxins in foodstuffs, it is recommended that a sampling plan of 100 incremental samples and an aggregate sample of 10 kg is used for lots >50 tonnes, whereas for smaller lots the recommended number of increments is approximately proportional to the square-root of the lot size.

The procedure for sampling flowing grain by mechanical means specifies that a minimum of 20 incremental samples (of a mass between 300 and 1900 g) per sub-lot of 500 t be taken.

Thus, in order to form a representative sample, it is necessary to take a large number of incremental samples and also grind an aggregate sample of substantial mass to ensure that the number of infected kernels in the sample is representative for the lot.