Sentence examples for an expected height of from inspiring English sources
The height of the nanopores is determined by the thickness of the OTS film, which has an expected height of 2.6 nm for a densely pack film.
The concept of an expected height was based on the national growth charts of Danish boys and girls.
Improvements in forecasting the expected height of storm surges and the issuing of warnings are necessary as the population of coastal areas continues to increase.
Thus, the expected height of these dimers was in the range of 19.6 37.6 nm if considered that the length of NDT molecule and diameter of AuNP are equal to ~1.6 and 18 nm, correspondently.
The effective radius of each of these point QDs is taken to be 3.5 nm, half the expected height of the QDs as determined from the results of Schmidbauer et al. [5].
After affinity purification of the antibody only the 50 kDa band remained visible (Fig. 1A, pur), which is the expected height of GFAP+1 protein as we confirmed by recombinant protein (not shown).
This implies that the expected height of the Singlebit trees is no more than 15 (as we aim for balanced trees cf. above).
At the same time and in spite of the non-specifically detected band at the same expected height of Gb-Ki4 scFv) Gb-Ki4 scFvbuffer control, withinld therebufferify the sucontroll internalization of the CFP.
The total rate of coalescence Rc (in coalescent units) due to both sweep and neutral coalescent events is then R c = 1 + k h = 1 + α λ r I α, s. (8)The expected height of the coalescent tree for two sequences is the inverse of this rate.
Health services are expanding, though from a low base: a recent study by the Lancet, a medical journal, found that around a third of Vietnamese children under five years old were still below their expected height because of poor nutrition.A welfare system along European lines is slowly emerging.
The height difference between the lowermost (ld-phase) and the observed medium height level (lo-phase without protein) was determined by line analysis, confirming the expected height difference of 0.6 nm between ld- and lo-phase prior to protein addition [22] [25].
