Sentence examples for an additional failure from inspiring English sources

Debonding is an additional failure mode considered in the global analysis.

A grade of B- or below in any course will result in academic probation for the following semester, while a grade of B- or below in two or more classes, or an additional failure (grade of B- or below) during the time a student is on academic probation, may be grounds for dismissal from the Ph.D. program.

Suture interfaces with a bonded tip region exhibit a higher initial stiffness due to the greater load bearing by the skeletal teeth, a double peak in the stress strain curve corresponding to the failure of the bonded tip and the failure of the slanted interface region or tooth, respectively, and an additional failure and toughening mechanism due to the failure of the bonded tip.

Call rates were high with one sample that could not be genotyped at all and an additional failure in GSTT1 and GSTP1 genotypes.

An additional failure (grade of B- or below) is grounds for dismissal from the Ph.D. program.

An additional failure mode intrinsic to the textile architecture was encountered for loading in the heavily undulated braid yarn direction.

Fuel performance model calculations with the PANAMA code have shown that for the temperature distribution given, only a small additional failure fraction is expected.

The influence of relevant socio-demographic and clinical parameter on the total direct medical costs was tested: Besides MARS a significant influence was seen only for creatinine indicating that an additional renal failure respectively multiorgan failure was responsible for higher costs.

Finally, an 8.8%% failure rate in month 0 was considered for both arms of the model, and an additional device failure rate of 1.76 per patient was included at month 13 for conventional rods.

A few additional failures during the process is also compensated by the fact that k-means tuning also happens when a swap is accepted even if it is not considered as successful swap by the theory.

This paper expands the geometry assumptions so that additional failure modes will be kinematically admissible.