Sentence examples for amp input from inspiring English sources

The sensor board has a bandwidth of 100 KHz, gain of of one volt out per amp input, and with an output noise of about 7x10-5 volts.

Low-voltage applications are defined here as single-supply applications, and in single-supply design, the op amp input voltage and output voltage are referenced to the midpoint of the power supply (Vcc/2).

USB Flashlight-er 2.4" length 4-18 mA NiMh cells 20 minutes operating time 18 hr charging time Light intensity of 3600 mCd USB charging capacity 1 Amp Input 12 to 15 volts at 600 mA nominal.

Plug the big end into amp input.

The output of the Korg AX100G effects processor is located on the left side of the processor, while the power amp input is located either on top of the unit, or on the "face" of the unit (the input is almost always located near the amp's tone controls).

This requirement for biasing the op amp inputs to achieve the desired output voltage swing complicates single-supply designs.

The amplifier should remain connected to the receiver with an RCA cable between the amplifier outputs and the amp inputs on the receiver.

USB Pass-through Flashlight-er 3.5" length 4-20 mA NiMh cells 20 minutes operating time 18 hr charging time Light intensity of 3500 mCd USB charging capacity.5 Amps Input 12 to 15 volts at 600 mA nominal.

Some amplifiers might have tape monitor input rather than pre-amp input channels so you can also use these.

Connect the other pair of cables from the output channels on the back of the equalizer to the pre-amp input channels on the amplifier.

Connect one pair of cables to the pre-amp output channels on the amplifier and the other end of the cable to the pre-amp input channels on the equalizer.