Sentence examples for amounts of extension from inspiring English sources

In this study, the total amounts of extension and stretching factor (β factor) have been measured for six transects across the entire passive margin of the Otway Basin region.

Comparing each of the plastic types overall, it was evident that the ductile 75:25 albumin-water and the 80 20 albumin-rubber plastics were the best types of bioplastic to use, depending on the intended use, as the water-based samples allowed large amounts of extension before breaking, while the rubber-based samples were stiff and required the highest amount of load needed to break the samples.

On the other hand, in vitro chemical synthesis of PAs has also been reported [ 73] and these authors observed a modulation of polymer size through the modulation of the relative amounts of extension unit intermediates and monomers.

In contrast, the region with the largest β factor and amount of extension is related to younger and thinner lithosphere of the Lachlan Orogen.

Effective elastic thickness, Te, varies between 24 and 30 km and is unrelated to either the amount of extension or the maximum sediment thickness.

Across the study area, differences in both the morphostructural features and the amount of extension are obvious from the west to the east.

In terms of the amount of extension that occurred before breaking, the 75:25 albumin-water plastics possessed by far the highest amount of extension, extending nearly 200% on average before a ductile break; the other plastics extended around only 75% before breaking (Figure 7) as the glycerol and natural rubber plastics were statistically undistinguishable (p = 0.943).

Thus, in order to determine the total amount of extension responsible for the formation of a basin system, it is necessary to independently constrain the flexural strength of the lithosphere both during and after extension.

If this type of crust is common then this allows for the possibility of non-uniform strain accommodation (i.e., where the amount of extension is not the same through the plate).

(d) Grip, transport and position the loose side plate or suspension system from their initial positions to their exact new position of the RVS machine based on the amount of extension or reconfiguration required by the maintenance manager in order to increase the screening capability of the RVS machine.

Calculations using Ericksen's Transversely Isotropic Fluid model show that the addition of a modest amount of extension to otherwise shearing kinematics can influence alignment by perturbing tumbling orbits either into or out of the shear plane, in addition to inducing a transition from tumbling to flow aligning behavior.