The phrase "amount oxidation" is not correct and does not convey a clear meaning in written English.
It may be intended to refer to the quantity or degree of oxidation in a chemical context, but as it stands, it lacks clarity and proper grammatical structure.
Example: "The amount of oxidation in the reaction was higher than expected."
Alternatives: "level of oxidation" or "degree of oxidation".
The amount and oxidation state of As co-precipitated with Fe(III) are controlled by the co-oxidation of As III) with Fe(II), which increases with initial Fe/As ratio, and the competitive uptake of phosphate, As V) and less strongly sorbing silicate and As III).
For example, over the last 10-day period, the amount of oxidation associated with the bacteria/lipid/pyrite system was a factor of three higher than the rate of oxidation associated with the abiotic lipid/pyrite system, and it was very similar (within experimental error) to the rate of oxidation associated with untreated pyrite in pH 2 water (i.e., no bacteria or lipid).
Carbon mass balance calculations showed that EF-Persulfate leaves the lowest amount of oxidation by-products in the system.
An increased crystalline order lowers the amount of oxidation and the aging of polar functional groups on the substrate surface.
The effect of trimethylolpropane triacrylate (TMPTA) is to lower the amount of oxidation, especially at relatively higher levels.
The roughness and the nature of surface profile suggest considerable amount of oxidation have occurred at the track length of ± 25 μm compared to that of ± 5 μm.
In the absence of dissolved oxygen the overall consumption of formaldehyde is limited by the amount of oxidation products on the silver surface, the redox process does not occur at all for reduced state of the silver surface.
The order of catalytic activity of CO2 reduction was found to be Pt(110)〉 Pt(100)〉 Pt(111); maximum charge amount of oxidation of reduced CO2 at Pt(100) was found to locate on terrace sites but not on edge sites.
Figure 1 The amount of oxidation, based on the solution concentration of Fe, for the various pyrite systems.
The small band at 1,050 cm-1 due to Si-O stretching modes suggests a small amount of oxidation has occurred after etching [21].
