Sentence examples for amount of the reactant from inspiring English sources

There was no clear information to the amount of the reactant fed during the process but a ratio around 10 1 paraffin to polyunsaturated hydrocarbon was emphasised with the paraffin concentration always higher than the concentration of the hydrogen acceptor.

Therefore, the total amount of the three components (GL, VL, and LA) remained fairly constant as the reaction went on (Fig. 3), simply because of the decrease in the amount of the reactant, vinyl laurate (VL), which was accompanied by an increase in the formation of both the product, glucose laurate (GL) and the co-product, lauric acid (LA).

In particular, each Reactant Tot function without SORLA is transcribed as function of APP init, α init, and β init, whereas those with SORLA are transcribed as function of APP G1, APP G2, α 1, α 2, β 1, and β 2. (III) The amount of the Reactant init in each Reactant Tot with SORLA is set to be the same as that calculated from the corresponding Reactant Tot without SORLA.

The amount of the reactants was calculated based on the Ca/P molar ratio (10/6 = 1.67).

H2SO4 as catalyst, 0.25% (w/w) hydroquinone (with respect to the total amount of the reactants) as polymerization inhibitor and toluene as solvent in a Dean Stark apparatus.

In the HSC Chemistry software 6.0, the reaction system needs to be specified, in terms of its phases and species, and the amount of the reactants.

The initial amount of the reactants, feed addition profiles, addition time, number of continuously added feed and interaction between two feed flow rates are optimized comprehensively, subject to various process and system constraints.

The study shows that the core size and shell thickness could be tuned simply by controlling the addition amount of the reactants and the addition way; that through further processing (e.g. grafting other functional molecules on the particle surface), advanced materials could be prepared; and that the hollow silica spheres could be potentially used as a novel class of catalyst supports.

Measure out a precise amount of analyte (the reactant mixed in with the unknown).

From the previous section on stoichiometry, it is clear that stoichiometric considerations may affect the relative amounts of the reactants that are consumed.

In the typical procedure, certain amounts of the reactants, HDA and DMC, and the AlPO4 or ZnAlPO4 catalyst were added into the three-neck flask at room temperature, before the introduction of a nitrogen flow to drive out the air contained in the flask.