The phrase "amount of the component" is correct and usable in written English.
It can be used when referring to the quantity or measurement of a specific part or element in a larger context, such as in scientific, technical, or manufacturing discussions.
Example: "The amount of the component needed for the experiment was precisely measured to ensure accurate results."
Alternatives: "quantity of the component" or "volume of the component".
A better approach would be to tax the drug based on its potency — which can be measured in various ways, including by the amount of the component THC in a batch — and increase the rate over time to keep up with inflation.
The results from GC analysis show that: the amount of the component of lavender essential oil is 84 obtained by microwave combination of steam distillation with more than of 0.05% before the retention time of 40 minutes, compared with supercritical received only 65.
Table 1 The proximate analysis of S. officinarum Component Amount of the component Hemicellulose 23.30 Cellulose 28.20 Lignin 17.80 Moisture 8.21 Ash 7.60 Volatile matter 14.89.
As a result, the efficiency of complex synthesis (defined as the ratio of the number of whole complexes to the amount of the component with lowest abundance; see Methods) decreases [ 22, 23].
An efficiency of complex formation can be defined in our model as the ratio of the number of full complexes to the amount of the component with lowest abundance: [ABC]/min(A0, B0, C0).
The percent yield of a component may be calculated by the formula (1) % yield = 100%% ∗ ∑ i = 1 n AWF i + ∑ i = 1 n RF i total, where the "total" is the amount of the component in the leaf prior to recovery, assumed to be the sum of the yields from all the AWF and all the RF from every round of recovery as well as the yield in WHE (the homogenized tissue from which the AWF had been recovered).
The specimens differed by the amount of the components (differences in burning regime were insignificant).
The enzyme immobilization efficiency is examined by varying the amount of the components and the immobilization procedure.
Specific feature of this process compared to the conventional EC' mechanism is the progressive increase in the overall amount of the components of the redox couple owing to consumed bromate.
For MgH2/NaAlH4 and MgH2/Na3AlH6, it is shown that reaction mechanisms in the composites depend on the relative amount of the components.
Degradation rates for five glycerol polyester blends were determined from the amounts of the component acids released.
