The phrase "amount of mills" is not correct in standard written English.
It may be intended to refer to a quantity of mills, but the word "amount" is typically used for uncountable nouns, while "mills" is a countable noun.
Example: "The amount of mills in the area has decreased over the years."
Alternatives: "number of mills" or "quantity of mills".
By using this attritor, optimum processing parameters such as milling time, milling speed (rev/min), diameter and the amount of milling balls, milling atmosphere were determined when MM'ing of gas atomized 17-4PH steelless steel powders were carried out.
amount of stabilizer (Pluronic F68) and amount of milling agents (Zirconium beads) on dependent variables, particle size and % drug release at 30 min.
The TLM loaded nanosuspensions were optimized by implementation of 32 full factorial design along with principal component analysis (PCA) with concentration of stabilizer and amount of milling agents as factors.
The most important factor in determining a sake's style is the amount of milling given to the rice.
The weight of steamed rice is about twice the amount of milled (raw) rice, e.g., when we steam 100 g of milled rice, the weight approximately doubles (212 g in the food composition table).
In the current study, the interactions are few in number so even though we can find relevant sites, a significant amount of milling time still has to be invested to catch CNTs in the action.
If a small amount of milling liquid is pre-aspirated, these air bubbles can be used as boluses to physically separate dissected areas or place an air bolus between the plunger and the recovered liquid, which can be used to increase recovery efficiency.
By using this attritor, optimum processing parameters such as milling time, milling speed (rpm), diameter and the amount of the milling balls, milling atmosphere and raw material properties were determined when mechanical milling of gas and water atomised 17-4 PH stainless steel powders.
The technology of wide range of sizes "140" pipe-rolling plant 156 mm diameter continuous casting pipe production was developed to use one roll design on piercing mill and one roll design on reeling mill instead of two roll designs for each therefore decreasing the amount of sizing mills grooves.
In the present work grinding of brass particles is studied in detail in a laboratory size ball mill to determine the optimal levels of the ball to material ratio, type and amount of additives, mill speed, ball load, etc.
