Sentence examples for amount of injection from inspiring English sources

Effects of the angle, location and amount of injection on pressure levels are investigated.

The amount of injection for each core was two pore volumes.

As seen in the input data from Table 2, the amount of injection pressure is very high.

While Thiele and Batycky approach with α = 2 tends to reduce the injection rate of well 1, using this approach with α = 1 increases the amount of injection rate.

Use of the polymeric waterflood is a technique to enhance oil recovery from a reservoir by improving the reservoir sweep and reducing the amount of injection fluid needed to produce the same amount of oil (Sorbie and Phil 1991).

In this case, if the wellbore pressure is not sufficient, the compaction failure will happen (as seen in the input data from Table 2, the amount of injection pressure is low).

1581 psi for the gas well and 1547 psi for the water well were determined through strictly equalizing amounts of injection phases for the conventional foam between two modes.

Based on the finding, the nitrogen injection method and the amount of nitrogen injection were given at different face advance speeds.

Following the manipulations above, at first, we set an equivalent gas well injection pressure, 1585 psi, to chase the same amount of gas injection with that under the constant rate mode; then, a higher injection pressure is applied, 1610 psi, to validate our conclusions, as summarized in Table 8.

These protocols differ for example in the effective patient dose, the amount of contrast injected, injection rate, delay times, image reconstruction algorithms, contrast weightings, slice thicknesses and image orientation.

Injection amounts varied from 0 to 15 times the amount of GABAB1a injection (Figure 6).