Several factors related to bracket/wire combination can influence the force released to the teeth, such as arch dimension, amount of deflection, ligation method, and frictional forces [8 10].
Amongst the various variations in position, amount of deflection, height, length, and width of T-loop in a study by Chaudary et al. [22] in 2013, the biomechanical properties of T-loop of height 7 mm made of 0.017 × 0.025 TMA placed in the center of extraction space showed variable results in terms of force and M/F ratio.
From simulation results, it was found that the exit velocity of the workpiece varied depending on the cross-sectional thickness of the exit and the amount of deflection of the workpiece was not greatly affected by variations of either the workpiece temperature or punch velocity under the present simulation conditions.
The device uses a magnet to bend the trajectory of a beam of ions, and the amount of deflection is determined by the ratio of an atom's mass to its charge.
¥ The difference between UMWs and USWs in the force exerted at the same amount of deflection was statistically significant, but the difference between LMWs and LSWs did not always reach statistical significance (Table 3).
In general, for the smallest amount of deflection (0.5 mm), there was a trend, in any diameter and type of wire tested, that the force exerted by EL were much smaller than those of other ligation types.
It can be concluded from Figs. 5, 6 and 7 that epoxy repaired frames have reduced amount of deflection for the similar value of load in comparison to braced frames.
It can be concluded from Figures 5, 6, and 7 that epoxy-repaired frames have reduced amount of deflection for the similar value of load in comparison with braced frames.
The tested beta-titanium alloy wires showed a statistically significant difference in load/deflection behavior and indicate that different forces exist for the same amount of deflection even though the 'same' alloy is used.
By doing like this, we expected that the amount of deflection of the metal plate can be made smaller than the right angle, and unnecessary force witch is the cause of stick-slip vibration will not be applied.
