The phrase "amount of calibration" is correct and usable in written English.
It can be used when discussing the quantity or degree of calibration needed for a device or system.
Example: "The amount of calibration required for the new equipment is significantly higher than we initially anticipated."
Alternatives: "level of calibration" or "degree of calibration".
This decision was made in order to simplify the amount of calibration that would be required to get a precise timing from every user.
In many measurement tasks, the amount of calibration data is increasing nowadays due to new devices like hyperspectral imagers.
A comparison between these two figures shows the amount of calibration level in compare with the experimental modeling frames.
Likewise, the inclusion of physical models of PET images such as a point spread function (PSF) is also dependent on some of the parameters listed above and therefore would require a considerable amount of calibration measurements.
There was only a slight amount of calibration bias and spread, indicating that at locations where the predicted probability of occurrence was >∼60% the model slightly overestimated the frequency of An. coluzzii, and conversely, at localities below the 60% threshold, the model underestimated the relative frequency of An. coluzzii.
Nursing workload for glucose control per day was determined by the number of POC measurements or measurements from the sensor, which were entered in the computerized glucose regulation protocol and the amount of calibrations of the CGM sensor (in the intervention group only).
The amounts of calibration pressures and axial feedings required to produce an acceptable product in FEM were compared to experimental results and it was shown that there is a good agreement.
If virtual sensors were calibrated using laboratory data, the amount of the calibration data could be minimized using design of experiment techniques.
The large amount of collected calibration data allows careful studies of the stability of constants, like pedestals and pulse shapes.
As noted in the previous section, even though the same calibration source was used, there was a significant amount of intra-calibration source variation.
The amount of mis-calibration was found to increase with the degree of clustering.
