The phrase "amount of adhered" is not correct in standard written English.
It seems to be an incomplete expression and lacks clarity, as "adhered" typically requires a noun to specify what is being adhered to.
Example: "The amount of adhered material on the surface was significant."
Alternatives: "quantity of adhered" or "level of adhesion".
Fixation of biological tissue with glutaraldehyde or genipin significantly increased its hydrophilicity and surface tension and reduced its mol ratio of adsorbed fibrinogen to adsorbed albumin as well as the amount of adhered platelet.
Material from the work piece was observed to adhere to the inserts during turning and the amount of adhered material and its chemical composition is independent on the Al-content of the coating.
It was found that, after the immobilization of the biomacromolecules, the water contact angle and the amount of adhered platelets and macrophages on the membrane decreased significantly when compared with the nascent ones, indicating the improvement of surface hydrophilicity.
Several factors can influence the compressive strength in RCA concrete, including the water/cement (w/c) ratio, the percentage of coarse aggregate replaced with RCA, and the amount of adhered mortar on the RCA.
The amount of adhered fibroblasts on CNTs/SF electrodes of quartz crystal microbalance (QCM) greatly exceeded those on other surfaces.
A tendency toward a higher amount of adhered bacteria on the two surfaces was seen after incubation at pH 9.0, indicating a tolerance among oral bacteria to alkaline environments.
On the other hand, however, most studies indicate a positive correlation between surface roughness and the amount of adhering bacteria [1, 9 11, 19, 20, 22, 23].
In addition, Taylor et al. could not clearly relate surface roughness of PMMA surfaces to the amount of adhering S. epidermidis, which supports the results of the present study [41].
Figure 2a b both showed the phenomenon that the SERS effect of the samples improved with the amount of adhering Au nanoparticles until the sputtering time of 240 s, and then, the Raman peaks' intensity of BPE decreased a little when prolonging the sputtering time.
The SS electrode needle tip showed a significantly higher amount of adhering tissue than the TiO2-coated electrode (P < 0.05).
A considerable amount of soil adhered to the surface of the smooth blades, but little adhered to the rough blades.
