Sentence examples for amorphous model from inspiring English sources
Figure 2 shows the procedure for the construction of the amorphous model.
Fig. 2 Process of amorphous model construction Fig. 3 RDFs of different Si phases.
It is shown that the pair distribution function for the ideal amorphous model relates to the pair correlation function obtained from the dynamic model.
It is clearly indicated in Fig. 14c that a small stable crystalline cluster is formed by a low-temperature annealing of the melt-quenched amorphous model prior to the neuromorphic simulations, followed by a subsequent growth proportional to the magnitude and duration of the applied heat pulses, as illustrated in Fig. 13.
The response of amorphous model PEO48NaI, PEO20NaI and PEO3NaI polymer electrolytes to a rapid increase in temperature followed by a cooling phase of similar duration is investigated by molecular dynamics (MD) simulations.
Using a Cu Zr binary amorphous model constructed by rapid quenching in the framework of molecular dynamics simulations, Voronoi polyhedra analysis shows that the icosahedra are not randomly distributed in space, but form characteristic interpenetrating icosahedral clustering with medium-range order.
A minimum of three periodic boundary condition amorphous models was constructed and analysed in terms of solubility parameter, X-ray pattern, pair correlation function, hydrogen bond fraction and backbone conformation.
A rate-dependent amorphous plasticity model which accounts for cavitation and related failure phenomena is used to model the grain boundaries, while a crystal plasticity model is used for the grain-interiors.
After porous analysis and gas adsorption test, the result showed CO2 uptake capacity of CMPs-DTBT with amorphous aggregation model is 2.88 times and 2.66 times greater than that of CMPs-TTT with large lamellar structure model at 273 K and 298 K (1.0 bar), respectively.
The proposed amorphous viscoplastic model minimizes the numbers of material parameters, and it significantly facilitates the calibration process.
With 48 45 mN/m at 120 165 °C, the highest surface tension was determined for an amorphous HS model.
